learning the basics of home septic systems
About Me
learning the basics of home septic systems

A septic system is something that is easily forgotten until something goes horribly wrong. What should you avoid running down your kitchen sink? Is one type of toilet paper safer to use than another? How often does your septic tank really need to be cleaned? These were just some of the questions that I had about my septic tank after it had backed up and filled my yard with raw sewage. Since then, I have spent hours researching septic systems so that I would not have to go through that again. I have developed my website to make learning about septic systems a little easier for others like me.

learning the basics of home septic systems

How To Install A Larger Window In Your Living Room

Matthew Young

Did you get tired of that old window in your living room and want a new, larger one? But you don't want to pay a lot of money for window services, right? Well, there is absolutely no reason to worry because this guide is going to help you install a new, larger window in your living room by yourself. Before you begin, make sure that you have a circular saw, a pry bar, and a screw gun.

There are also some materials that you are going to be using during this process. They are cedar shims, wooden window sill, and some roll insulation. Once you are sure that you have all of this, you can begin with the installation process of a new window.

Removing the Trim and Window Casing

The first thing that you need to do is to remove the jamb extension and the window trip with a pry bar. Removing the jam extension doesn't have to scare you at all because it is just a piece of wood used for bringing the window jamb even with the wall.

Removing the Old Window and Preparing the New Window Opening

You can simply remove the window from the jamb by simply unscrewing it with a screw gun. However, be careful and make sure that the glass stays in one piece. It is now time to prepare a new window opening. First check to see if there is any structural damage, and if there is not, you can proceed.

It is a good idea to measure your rough opening, just to make sure that the new window will fit nicely. Knowing the exterior dimensions of your new window is important because you need to make the rough opening anywhere from 1/4'' to 3/8'' larger than them.

Inspecting the Window Stop

The goal of a window stop is to make sure that the window doesn't slide out of the opening. Usually, there is no need to do anything when it comes to the window stop because it stays in one piece more often than not. But if your window stop is damaged, then you need to either replace or repair it. However, once again, this is very unlikely to happen.

Make sure that everything is as it should be by dry fitting the window before you apply the silicone to the stop. If everything is done correctly, the window will fit nicely into the opening.

Installing the Window

Installing the window is actually pretty simple. Put some silicone on the inside of the stop, and then simply slide the window into place. Place one level across the top. Then take cedar shims and press them between the jamb and the bottom of the window frame. Now you just need to add the screws in the pre-drilled holes.

You may need to insulate some areas, but that is not hard at all. And you can use the expanding spray insulation foam to reach the harder spots.

You are not finished yet. Use the miter saw to cut the trim. Make sure that every single one of your cut is a 45-degree angle cut. And then use the finish nails to attach the trim to the wall. Adding thin strips of wood trim inside the original window frame may be necessary as well.

Choose Your Drapes

With an investment in such a nice window, you may want to consider custom draperies for your new home feature. The perfect drapes will complement and enhance the window while also being functional and convenient to use. With larger sized windows, it can be hard to find the right pre-made drapes. Custom draperies tailor the fabric directly to your window and its surroundings, while also cutting it to the correct length and width.

You can still always call one of the replacement windows services if you are not feeling comfortable doing this by yourself, or if you don't have the necessary tools. After all, they are professionals, and they are, after all, the experts. Visit a site like http://www.bramblebuilders.com for more.


Share